The thruster is mainly used for the driving role of the hydraulic brake system

The application of the thruster:
The thruster is mainly used for the driving role of the hydraulic brake system. Suitable for DC380V,330W system; It has the characteristics of smooth starting, low noise, anti-interference and energy saving and environmental protection. It is widely used in lifting, driving and other large equipment to improve the performance accuracy of the driver and reduce the cost.
Advantages of the use of the thruster:
1.Overload automatic protection function is reliable, even in overload or to the end of the trip, it can maintain the normal operation of the motor, without causing other parts to burn or damage. Electric thrusters and electric actuating mechanism are not comparable.
2.Compared with the difficulties of electric thrusters and electric actuating mechanism, electric hydraulic thrusters can start under load.
3.The thrust and pull of the same driver can be stepless adjusted within the rated range, so the range of drive can be wide, but the electric thruster and cylinder can not be achieved.
4.When the thrust and speed are equal, the electric hydraulic thruster consumes more power than the electric thrusters and electric actuating mechanism.
5.The thruster is a fully hydraulic driven thruster, its sensitive action, smooth operation, can effectively reduce the impact of the outside, stroke control is accurate, and the cylinder, electric thrusters and electric actuating mechanism can not achieve this.
6.The electric hydraulic thruster for the electrohydraulic integration of the fully closed structure, the working oil circuit in the steel closed cylinder circulation, no pressure, small size, no oil leakage, easy installation and maintenance. No suction, no water absorption, no internal rust, longer than the cylinder, electric thrusters and electric actuating mechanism life.
7.Less investment, the cylinder needs expensive air compressor station, and the pressure pipeline is easy to leak, resulting in unstable air pressure, resulting in greater noise; The hydraulic cylinder needs to set up a hydraulic station, and the electric hydraulic actuator needs to be connected to the same power supply.
8.Easy maintenance. The electric hydraulic thruster only needs to be replaced in special cases, and the hydraulic cylinder needs to be slowly found out where the fault lies before the overhaul, and it needs to be carefully overhauled, which will affect the normal operation of the entire working system.